The OEM splash guards were designed around the OEM fender flares, which made it impossible to remove the OEM splash guards, without leaving the end of the flares open and unfinished. The OEM splash guards also prevented installing the Gatorback mudflaps properly. The Finishing Caps solve this problem.

• Provides more clearance for slightly larger than stock tires
• Completes fender flares when OEM protectors are removed
• Mud flap deletes for removal of OEM splash guards
• Fits: 2020-2024 Chevy Silverado 2500/3500HD
• Includes (2)finishing caps (Front Wheels)
• Trimmable to provide more tire clearance
• No drilling required for installation
• Does NOT fit the ZR2 submodel
• Does NOT fit GMC trucks.
• Install Time: 15 minutes

This Part Fits:

The OEM splash guards were designed around the OEM fender flares, which made it impossible to remove the OEM splash guards, without leaving the end of the flares open and unfinished. The OEM splash guards also prevented installing the Gatorback mudflaps properly. The Finishing Caps solve this problem.

• Sold as a set of 6 (front wheels, front of rear wheels and rear wheels)
• Fills gap left when the factory mud guards are removed
• *Does not fit the 2024 AT4X, but will fit 2024 AT4.
• Matches factory flare molding perfectly
• Custom fit, no drill install
• *Does NOT fit the Chevrolet
• Install Time: 0.5 Hours

This Part Fits:

These caps are custom designed to fill that section. They are made of the same material and have the same finish and texture. They will give a seamless look without the mud flaps.

• *These do not fit the AT4X, but will fit the AT4. *Does NOT fit the Chevrolet
• Sold as a set of 6 (front wheels, front of rear wheels and rear wheels)
• Fills gap left when the factory mud guards are removed
• Matches factory flare molding perfectly
• Custom fit, no drill install

This Part Fits:

The Cognito Front Fender Liner Tie Back Kit makes fitting larger tires and offset wheels easier on your 20-23 Silverado/Sierra 2500/3500 trucks.For the front fender well, rear lower fender liner brackets, these new brackets bolt on after removing the stock fender liner brackets. The new brackets tie the lower rear portion of the front wheel well fender liner back further to clear larger tires and offset wheels.On a 3-Inch Leveled Trucks, this kit allows for up to a 35x12.5-Inch Tire on a 9-Inch Wide Wheel with -18mm to +18mm offset, 10-Inch Wide Wheel with 0mm to +10mm offset. 37x12.5-Inch Tire on a 9-Inch Wide Wheel with +18mm offset.Please Note: If using factory mud guards, they must be trimmed as shown in the instructions.

• Please Note: If using factory mud guards, they must be trimmed as shown in the instructions.
• No trimming is required to install if leaving off the factory mud guards
• All necessary installation hardware
• Powder-coated semi-gloss black
• 30-minute DIY install time
• Easy Installation
• Made in the USA

This Part Fits: